Kent Elastomer excels at finding solutions for difficult applications or meeting tough deadlines. By specializing in small to medium run batches of dip molded applications, we offer our customers the ultimate flexibility when it comes to a wide choice in shapes, sizes, wall thicknesses and colors of both latex and non-latex compounds.

Thanks to Kent’s experienced design personnel, start-up costs are minimized and product development cycles are shortened. Our low-cost prototype development is an added plus.

We produce both latex and latex-free products for a variety of markets. Hyperinflation non-latex anesthesia breather bags, probe covers, surgical inflation devices, and penrose drain tubes are just a sampling of what we provide the medical market. Kent's ability to dip a variety of compounds makes our capabilities the perfect solution for your dip molded product requirements.

Dimension Requirements

- Part dimensions should be in the range of 1" to 24" in length and 1/4" to 12" in diameter. - Parts can be no larger than 5 times the diameter of the open end. This permits stripping   the part from the dipping form without undue stretching or damage. Parts cannot be solid. - If you have an unusual shape or size, please contact us to see if we can accommodate   your needs.

Form Guidelines

- Forms should have rounded contours to allow material to flow during dipping. - Sharp angles and/or flat surfaces parallel to the surface of the material should be avoided. - Customer may provide forms or we will have forms made to customer specifications. - Detailed dimensional drawings insure accurate tooling of forms.